Parcourir les catégories
Explorer
Fiverr Pro
Français
$
USD
I will develop ultra thin rfid pcb with rf design, antenna tuning and matching network
pcb design and firmware development
Hi, I’m Taylor a PCB Design and Embedded Systems Engineer specializing in custom hardware and firmware development. I design production-ready PCBs, develop reliable embedded C/C++ firmware, and build...
À propos de ce service
Hello and Welcome!
Are you building a compact RFID device that requires precision RF performance and optimized antenna tuning? I will develop your Ultra-Thin RFID PCB including RF circuit design, antenna development, matching network optimization, and high-frequency layout best practices for reliable performance in the UHF band (860960 MHz).
What I Offer:
- UHF RF circuit design
- Custom antenna design (dipole, loop, compact, meandered)
- Antenna tuning guidance
- Matching network calculation & optimization
- Controlled impedance PCB layout
- Ultra-thin stackup planning
- Signal integrity & grounding optimization
- Production-ready Gerber files
- BOM and fabrication documentation
Why Choose Me?
- Strong RF and high-frequency PCB expertise
- Focus on real-world read range and performance
- Clean, manufacturable PCB layouts
- Engineering-driven approach (not template design)
- Clear communication and complete documentation
If you are serious about building a high-performance ultra-thin RFID solution, message me before placing an order so we can define the best RF architecture for your project.
Lets engineer it properly from the ground up!!
FAQ
What frequency band do you design for?
I design UHF RFID systems in the 860–960 MHz range, optimized for US, EU, and global standards.
Do you design custom RFID antennas?
Yes. I design compact dipole, loop, and meandered antennas tailored to your size and read range requirements.
What does antenna tuning include?
I provide matching network calculations and tuning guidance to optimize impedance and maximize read range.
Do you handle impedance matching?
Yes. I design and optimize matching networks between the RFID chip and antenna for proper RF performance.
Can you design ultra-thin PCBs?
Yes. I optimize PCB stackup and layout to achieve thin profiles while maintaining RF integrity.
Will I receive production-ready files?
Yes. You will receive schematic files, PCB layout, Gerber files, BOM, and fabrication documentation.
